Samsung RF4267HABP User Manual (user Manual) (ver.0.2) (English, French, Spani - Page 10
CHECKING THE WATER DISPENSER LINE, INSTALLING THE WATER LINE, Connecting to the water supply line - filter
UPC - 036725560666
View all Samsung RF4267HABP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Checking the water dispenser line Installing the water line A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the ice maker to operate properly, a water pressure of 20~125 psi is required. Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in about 10 seconds. If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure. After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet. Connecting the water supply line to the refrigerator. There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store. Use Copper Tubing Use Plastic Tubing • ¼" copper tubing • ¼" plastic tubing • ¼" compression nut (1pc) → Molded end(Bulb) • Ferrule (2pc) • ¼" compression nut (1pc) Refrigerator Water line installation kits are available at extra cost from your dealer. We recommend using a water line installation kit that contains copper tubing and ¼" compression nut. Compression Nut (1/4") (Assembled) Plastic Tubing (Assembled) Compression Fitting (Assembled) Connecting to the water supply line 1. First, shut off the main water supply. Ferrule (Not supplied) Molded end(Bulb) Compression nut (B) (1/4") (Not supplied) 2. Locate the nearest cold water drinking line and install the pipe clamp and shut off valve. Cold water line Pipe clamp Shut off valve 3. Connect the water line installation kit to the shut off valve. Copper tubing or Plastic tubing (B) (Not supplied) (Not supplied) Household water supply line 1. Connect the household water line to the assembled compression fitting. - If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on the copper tubing (not supplied) as shown. - If you are using plastic tubing ( B ) , insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting. Cold water line Pipe clamp Shut off valve Water line installation kit Do not use without the molded end (Bulb) of caution the plastic tubing ( B ). 2. Tighten the compression nut ( B ) onto the compression fitting. Do not over-tighten the compression nut ( B ) . 10_ setting up