Samsung RS261MDBP User Manual (user Manual) (ver.1.0) (English) - Page 10

setting up your side-by-side refrigerator SETTING UP the refrigerator Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational. If not, first check the power supply and electricity source or try the troubleshooting section at the back of this user's guide. If you have any further questions, contact your Samsung Electronics service center. 1. P lace the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual. 2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors. 3. S et the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly. 4. A fter powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool. Check the accessory list below. LOCK Hex wrench Compression fitting Compression nut Clip Installing the handles 1. Take the handles out from the right side door. Screw The handles are included in the package. 2. Check if the word "UP" on the rear of the handle is facing right side up. 10_ setting up