Samsung SC-D385 User Manual (ENGLISH) - Page 18

准备

Get Samsung SC-D385 PDF manuals and user guides View all Samsung SC-D385 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

preparation USING THE BATTERY PACK • Use the IA-BP80W battery pack only. • The battery pack may be charged a little at the time of purchase. • Be sure to charge the battery pack before you start using your miniDV camcorder. Inserting / Ejecting the battery pack Insert 1. Open the LCD screen as shown in the figure. 2. Insert the battery pack into the battery pack slot until it softly clicks • Make sure that word mark (SAMSUNG) is facing out while the camcorder is placed as shown in the figure. 3. Slide the BATT. release switch and pull out the battery pack. • Gently slide the BATT. release switch in the direction as shown in the figure. • Additional battery packs are available at your local Samsung dealer. • If the miniDV camcorder will not be in use for a Eject while, remove the battery pack from the miniDV camcorder. Charging the Battery Pack 1. Slide the POWER switch downwards to turn off the power. 2. Insert the battery pack to the camcorder. 3. Open the jack cover and connect the AC power adaptor to the DC IN jack. 4. Connect the AC power adaptor to a wall socket. 5. Once charged, disconnect the AC power adaptor from the DC IN jack on your camcorder. • Even with the power switched off, the battery pack will still discharge if it is left inserted in the camcorder. It is recommended that you purchase one or more additional battery packs to allow continuous use of your miniDV camcorder. Use only Samsung-approved battery packs. Do not use batteries from other manufacturers. Otherwise, there is a danger of overheating, fire or explosion. Samsung is not responsible for problems occured due to using unapproved batteries. 14_ English 准备 IA-BP80W 1 LCD 2 BATT. POWER SAMSUNG 3. 轻推BATT BATT POWER CH BATT. BATT. BATT. BATT. POWER CH POWER 1 POWER 2 3 DC IN 接口。 4 5 上的 DC IN 中文 _14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
14
_ English
中文
_
14
只能使用
IA-BP80W
电池组。
在购买的时候电池组也许存有一些电量。
请在开始使用您的摄录机之前，为电池组充满电。
插入 / 取出电池组
1.
依图所示，打开
LCD
显示屏。
2.
将电池组放入电池组插槽，轻轻推挤电池组，
直到听到一声轻响。
依图所示，请确保装入电池组时，
电池上有
SAMSUNG
字样的一面朝上。
3.
轻推
BATT.
电池卡扣开关然后取出电池组。
按照图中指示的方向，轻推
BATT.
电池卡扣开关。
可在您所在区域的三星经销商购买电池组。
如果一段时间不使用摄录机，请将电池
组从摄录机中取出。
•
•
为电池组充电
1.
向下滑动
POWER
电源开关关闭摄录机。
2.
将电池组装入摄录机。
3.
打开接口仓盖，然后将交流电源适配器连接至
摄录机上的
DC IN
接口。
4.
将交流电源适配器的插头接到墙壁的电源插座。
5.
一旦充电完毕，请将交流电源适配器从摄录机
上的
DC IN
接口上拔掉。
即使电源为关闭状态，如果电池组仍然保留
在摄录机内，那么电池组也仍然会释放电量。
建议您将电池组从摄录机中取出。
为了您可以连续使用摄录机，建议您另外购买一块或多块电池组备用。
•
•
•
•
•
•
使用电池组
仅使用通过三星验证的电池组。不要使用其他厂商的电池组。
否则，有引起过热，起火或者爆炸的危险。
由于使用未经许可的电池组而引发的事故，三星公司概不负责。
准备
Use the IA-BP80W battery pack only.
The battery pack may be charged a little at the time of purchase.
Be sure to charge the battery pack before you start using your
miniDV camcorder.
Inserting / Ejecting the battery pack
1.
Open the LCD screen as shown in the figure.
2.
Insert the battery pack into the battery pack slot
until it softly clicks
Make sure that word mark (SAMSUNG) is facing out
while the camcorder is placed as shown in the figure.
3.
Slide the
BATT.
release switch and pull out the
battery pack.
Gently slide the
BATT.
release switch in the
direction as shown in the figure.
Additional battery packs are available at your
local Samsung dealer.
If the miniDV camcorder will not be in use for a
while, remove the battery pack from the miniDV
camcorder.
•
•
Charging the Battery Pack
1.
Slide the
POWER
switch downwards to turn off the power.
2.
Insert the battery pack to the camcorder.
3.
Open the jack cover and connect the AC power
adaptor to the DC IN jack.
4.
Connect the AC power adaptor to a wall socket.
5.
Once charged, disconnect the AC power adaptor
from the DC IN jack on your camcorder.
Even with the power switched off, the battery pack
will still discharge if it is left inserted in the camcorder.
It is recommended that you purchase one or more additional battery
packs to allow continuous use of your miniDV camcorder.
•
•
•
•
•
•
USING THE BATTERY PACK
preparation
Use only Samsung-approved battery packs. Do not use batteries from
other manufacturers. Otherwise, there is a danger of overheating, fire or
explosion. Samsung is not responsible for problems occured due to using
unapproved batteries.
BATT.
BATT.
BATT.
BATT.
BATT.
Insert
Eject