Samsung SC140 User Manual (user Manual) (ver.1.0) (English) - Page 4

Resolving Technical Problems  Please consult the following table BEFORE contacting your dealer or local SAMSUNG  representative. Problem The software installation failed I re-booted my PC and it paused during the start-up program. The disc tray does not open. Meaning / Solution x Check that your hard disk is not full. x The installation floppy disk may be corrupted. Repeat the installation with the backup floppy disk. After installing the device driver, your system start-up program may take more time than expected. If it does not start-up after 60 seconds, verify your AUTOEXEC. BAT file and, if necessary, contact your local computer dealer. The drive may not be installed correctly. Verify the physical installation. In the File Manager, the CD-ROM icon does not display. If you have installed the Then ... CD-ROM drive ... And the software Re-boot your PC. And have not installed the software Install the software following the instructions on page 5. I installed the software and rebooted my PC. The CD-ROM drive icon/directory still does not appear. x When the program of Windows 95/98 is broken up, re-stall x it as the computer can not read the program anymore. x Verify the connections between the drive and your PC. x Check that the 40-pin flat cable is connected to an IDE x interface (some PCs are equipped with an SCSI disk x interface). x Verify your AUTOEXEC. BAT file. Go to page 5 for x the verification procedure. x Check the LASTDRIVE = command in the CONFIG. SYS x file. The specified letter must take the CD-ROM volume x into account. If you do not know which letter is assigned x to the CD-ROM, enter Z. x Using the documentation provided with your PC, check x that the IDE hard disk is set up in MASTER mode. 6 Technical Specifications SAMSUNG continually strives to improve its products. Both the design specifications and these user instructions are thus subject to change without notice. SECTIONS SC-140 SC-148 DISC Disc types supported Disc diameter CD-DA, CD-ROM Mode-1, CD-ROM XA Mode-2 Form-1, Form-2, CD-Plus, CD-Extra, Photo-CD(Single, Multi-session), Video CD ready, Enhanced CD, CD-I/FMV, CD-R 12cm or 8cm Data transfer rate Max. 6000KB/s Max. 7200KB/s PIO Mode - 4. DMA MW2 Access time (1/3 stroke) 80ms(typical) 70ms(typical) DRIVE PER - Data buffer capacity FORMANCE Laser 128KB Semiconductor Laser Slide mechanism Gear motor Spindle motor Brushless motor Loading type ERROR RATE Tray Loading, DC motor(Soft Eject) Mode-1 : 1block / 1012 bits, Mode-2 : 1 block/109 bits Button Indicator(LED) FRONT PANEL Headphone output Open/Close Busy Stereo Mini - jack (¯ 3,6 mm) 0.60 ± 20% (Vrms) 33½ Volume control Dial type Required power +5V DC 1.7A, +12V DC 1.0A REAR PANEL Interface connector ATAPI Audio output Line out 0.70 ± 20%(Vrms), 47k½ Jumper block Device configuration jumper OPERATING Work area ENVIRONMENT Storage area Temperature : 5~45 ¡C, Humidity : 8~80% Temperature : -40~60 ¡C, Humidity : 5~90% GENERAL Dimensions 149(W) x 42.5(H) x 200(D)mm (Including bezel) Net weight 950g MTBF RELIABILITY 125,000 POH(Duty 20%) Disc compartment loading 30,000 times 7