Samsung SCC-C4301 Owners Instructions - Page 13

CTRL TYPE : You can select the A, B, C, or D mode depending on the input of the wired remote control terminal. (See page 7.) RS-485 : It sets up ADDRESS, PROTOCOL, and BAUD RATE of RS-485 communication. (BAUD RATE: 2400bps, 4800bps, 9600bps, 19200bps, 38400bps) Caution : A communication error may occur if you connect more than one camera set with an identical address. PIP : This is the Picture in Picture feature. It will show a screen reduced by 1/16 of the main screen only when operating the Digital Zoom. If you set the PIP option to ON and press the ENTER button, you can use the UP, DOWN, LEFT, and RIGHT buttons to set the PIP position. * The PIP feature does not work in a low speed shutter mode. The MIRROR feature does not work on the PIP window. (SPECIAL) EANGUAGE ENGLISH V-SYNC LINE... CTRL TYPE A RS-485 ... PIP ON MIRROR OFF D-ZOOM OFF POSI/NEGA + ZOOM SPEED 3 DETAIL (0) ----I-- RET Press the ENTER button. PIP MIRROR : Horizontally flips the video output signal. D-ZOOM : Sets the magnification of the Digital Zoom. The magnification level can be set to up to 10x. POSI/ NEGA : Outputs the video output signal normally or inversely. ZOOM SPEED : In the ZOOM SPEED option, use the LEFT and RIGHT buttons to set the speed as follows: 1 : Takes about 17 seconds from 1 x to 22 x magnification (slowest speed). 2 : Takes about 10 seconds from 1 x to 22 x magnification (slow speed). 3 : Takes about 6 seconds from 1 x to 22 x magnification (fast speed). 4 : Takes about 3 seconds from 1 x to 22 x magnification (fastest speed). DETAIL: Adjusts the sharpness. 23 AUTO FOCUS In the AUTO FOCUS option, you can specify the Focus method to AF, MF, or ONEAF. AF : Focuses automatically by continuously monitoring the screen in AUTO FOCUS mode. It does not process the FOCUS button input because it focuses automatically during ZOOM. MF : You can manually adjust (SET UP) the focus. CAMERA ID OFF E IRIS ALC... ONEAF : Focuses about 5 seconds only when ZOOM is SHUTTER AGC WHITE BAL OFF LOW ATW moved Wide to Tele. It is same as MF mode while in STOP SPECIAL AUTO FOCUS MOTION DET ... AF OFF mode, and same as AF mode after ZOOM Tele. PRESET COLOR/BW EXIT ... COLOR QUIT MOTION DET In the MOTION DET option, you can set the Motion Detection function, motion detection sensitivity, and the motion detection area. If you set the Motion Detection function, you can detect an intruder's movement and check it through the monitor and the ALARM OUT terminal. If you set ALARM which is located under COLOR/BW AUTO menu to ON while MOTION DET remains ON, the ALARM output port can not send any motion. (SET UP) CAMERA ID OFF IRIS ALC... SHUTTER OFF AGC LOW WHITE BAL ATW SPECIAL ... AUTO FOCUS ONEAF MOTION DET ON... PRESET ... COLOR/BW COLOR EXIT QUIT (MOTION DET) Press the ENTER button. AREA SENSITIVITY RET PRESET... MEDIUM 24