Samsung SH-S182M User Manual (user Manual) (ver.1.0) (English) - Page 31

Select Languages English Category SH-S182F(TS-H652F) DVD Writer DISC DVD : DVD-R, DVD-RW, DVD+R, DVD+RW, DVD-ROM, DVD-Video, DVD+R (Dual), DVD-R (Dual),DVD-RAM, DVD Multi-Border Usable Discs CD : CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G) CD-MIDI, CD-TEXT, CD-ROM XA, Mixed Mode CD CD-I, CD-I Bridge (Photo-CD, Video-CD), Multisession CD (Photo-CD, CD-EXTRA, Portforio) Disc Diameter 4.72 Inch or 3.15 Inch (120mm or 80mm) Interface Support Interface Port PIO mode ATA/ATAPI (E-IDE) PIO Mode 4: 16.6MB/sec DMA mode Ultra DMA Mode 2: 33.3MB/sec ACCESS TIME (Random) CD-ROM DVD-ROM 110ms (Random) 130ms (Random) Media Type Write Read DVD+R CAV 18X (24.3MB/sec) CAV 12X (16.2MB/sec) DVD+RW Z-CLV 8X (10.8MB/sec) CAV 8X (10.8MB/sec) DVD+R DUAL Z-CLV 10X (13.5MB/sec) CAV 8X (10.8MB/sec) DVD-R DUAL Z-CLV 8X (10.8MB/sec) CAV 8X (10.8MB/sec) DVD-R CAV 18X (24.3MB/sec) CAV 12X (16.2MB/sec) DVD-RW Z-CLV 6X (8.1MB/sec) CAV 8X (10.8MB/sec) Data Transfer Speed (Max) DVD-ROM (Single) DVD-ROM (Dual) - CAV 16X (21.6MB/sec) - CAV 8X (10.8MB/sec) DVD-RAM PCAV 12X(16.2MB/sec) PCAV 12X(16.2MB/sec) CD-ROM - CAV 48X(7.2MB/s) CD-R PCAV 48X (7.2MB/sec) CAV 40X (6.0MB/sec) US-RW Z-CLV 32X (4.8MB/sec) CAV 40X (6.0MB/sec) HS-RW CLV 10X (1.5MB/sec) CAV 40X (6.0MB/sec) CD-RW CLV 4X (0.6MB/sec) CAV 40X (6.0MB/sec) Buffer Memory 2MB Drive Installation Horizontal / Vertical Temperature Operating Environment Humidity 41°F ~ 122°F (5°C ~ 45°C) 5%~80%(RH) Size(Width x Height x Length) 5.83 X1.65 X 6.69 Inch (148.2 X 42 X 170mm) Weight 750g Note Does not support DVD-R for Authoring. Cannot playback or record on both sides of a two-sided disc simultaneously. The read/write capacity of the supported discs depends on the condition of the disc and the recording format of the drive. Therefore, the read/write quality may not be perfect. Severe vibration or external impact may decrease the quality of printed images. Please firmly place the product onto the PC before use. In case of disk identification error message, thoroughly clean the surface of the disk where the label is presented and then start printing. The quality of the printed image cannot be ensured if printing an image on the area which is already used for printing. For more information on the writing and duplicating the Lightscribe disk label, install Nero software and refer to the HELP section.