Samsung SL502 User Manual (ENGLISH) - Page 13
Connecting to a Power Source - cable
UPC - 044701011958
View all Samsung SL502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Connecting to a Power Source You should use the rechargeable battery SLB-10A supplied with the camera. Be sure to charge the battery before using the camera. Ê SLB-10A rechargeable battery Specification Model SLB-10A Type Lithium lon Capacity 1050mAh Voltage 3.7V Charging time Approximately 180 Minutes Ê Number of images and battery life: Using the SLB-10A Battery life / Number of images Conditions Using the fully charged battery, Auto mode, 12M image size, Fine image quality, Shot to shot interval: 30Sec. Still image Approx. 160 MIN / Approx. 320 shots Changing the zoom position between the Wide and the Tele after every shot. Using the flash on every second shot. Using the camera for 5 minutes and then powering it off for 1 minute. Movie Using the fully charged battery Approx. 125 MIN 640x480 image size 30fps frame rate Ä These figures are measured under Samsung's standard conditions and shooting conditions and may vary depending on the user's methods. 12 Important information about battery usage. å When camera is not in use, turn off the power. å Please remove the battery if the camera will not be used for long periods. Batteries can lose power over time and are prone to leaking if kept inside the camera. å Low temperatures (below 0°C) can affect the performance of the battery and you may experience reduced battery life. å Batteries will usually recover at normal temperatures. å During extended use of the camera, the camera body may become warm. This is perfectly normal. Ê If you connect the AC adapter to the USB cable, you can use it as an AC cable and recharge the spare battery with it. - Using an AC cable : Connect the AC adapter to the USB cable. It can be used as a power cable. - Using a USB cable : Remove the AC adapter.You can download stored images to your PC (p.91) or supply the power to your camera through the USB cable.