Samsung SM-352F User Manual (user Manual) (English) - Page 9
Setup - Connecting the Cable, Slave Drive Choose the SL Jumper
View all Samsung SM-352F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Setup Connecting the Cables Connecting the power cable The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the COMBO drive. A - Cut Side 1 +5V DC 2 Ground 3 Ground 4 +12V DC Note: An improperly connected power cable may cause trouble. Check the direction of the power connector and the incline side of the COMBO drive before connecting. Connecting the E-IDE cable Insert the IDE cable (40-pin), which is connected to the hard disk to the interface terminal. (Place the red line of the cable close to the Pin 1.) When using one E-IDE cable Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at the rear of the COMBO drive. a : Slave Drive (Choose the SL Jumper) b : Hard Drive c : MainBoard When using two E-IDE cable If there is only one COMBO drive, select MA (Master).