Samsung UN40D5550RF Quick Guide (easy Manual) (ver.1.0) (English) - Page 16
English - 16
View all Samsung UN40D5550RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Network Connection - Wired There are two main ways to connect your TV to your network using cable, depending on your network setup. They are illustrated below: The Modem Port on the Wall Extternal Modem (ADSL / VDSL / Cable TV) TV Rear Panel Modem Cable The LAN Port on the Wall LAN Cable TV Rear Panel LAN Cable Configuring the Network Connection - Wired Most home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networks that support DHCP automatically provide the IP address, subnet mask, gateway, and DNS values your TV needs to access the Internet so you don't have to enter them manually. To configure your network connection for a network that uses DHCP, follow these steps: 1. Connect your TV to your network as shown in one of the illustrations above. Network Settings 2. Turn on your TV, press the MENU button on your remote, and then select Network → Network Settings. The Network Settings screen will appear. 3. Select Wired, press ENTERE, and then press ENTERE again. 4. The Network Connection screen appears, and verifies the network connection. When the connection has been verified, the "Internet connection successful." message appears. Network set up is completed. Select a network connection type. Wired Wireless(General) WPS(PBC) One Foot Connection Connect to the network using LAN cable. Please make sure that the LAN cable is connected. Previous Next Cancel ✎✎If your TV cannot acquire network the connection values automatically or if you want to set the connection manually, select IP Settings on the network test screen. Set Internet Protocol Setup to Manual. You must enter the IP Address, Subnet Mask, Gateway, and DNS Server manually. ✎✎For more detailed information, see "Wired Network Connection" in the e-Manual. English - 16