Samsung WEP200 Quick Start Guide - Page 1

Quick Start Guide Bluetooth Mono Headset WEP200 Get connected in 4 quick steps Charge your headset Put your headset in pairing mode Turn on Bluetooth on your phone and pair with headset Test and use Start here Before using your headset Thank you for purchasing the Samsung Bluetooth Mono Headset WEP200, we hope you will be delighted with its operation. Take a moment before you get started to familiarize yourself with your new headset. Hook Volume control buttons Multi-Function button Indicator light Microphone Charging contact Check the accessories Make sure you have the following items with your headset: Set 1: Charging case, Travel adapter, Manual, 2 headset hooks Set 2: Charging case, Manual, 2 headset hooks For Set 2, use your phone charger as a power source for recharging. NOTE: Your headset supports the headset and/or hands-free profile(s). Headquarters: 1301 East Lookout Drive Suite 150 Richardson, TX 75082 Internet Address: http://www.samsungmobileusa.com/ accessories Customer Care Center: 1-888-987-4357 Guide No.: GH68-11254A 08/2006. Rev. 1.2 Put your headset in pairing mode Before you can use your headset, you must pair it with your phone. 1 Ensure that the headset is off (see Turn headset on/off on the reverse side of this guide). 2 Press and hold the Multi-Function button until the indicator light turns on in blue (approximately 8 seconds). The indicator light flashes in blue as you press and hold the Multi-Function button. Continue holding down the button until the blue light is steadily lit. Turn on Bluetooth on your phone and pair with headset 1 Set your Bluetooth phone to discover the headset by following your phone's guide. Typically, the steps involve going to the Settings, Connection, or Bluetooth menu on your phone and then selecting the option to discover Bluetooth devices. Your phone will find the Samsung WEP200 headset. 2 Select Samsung WEP200. 3 When the phone asks if you want to pair with it, confirm by selecting Yes or OK. 4 Enter the headset passkey or PIN, 0000. Charge your headset Charge the headset's battery fully before using the headset for the first time. 1 Put the headset in the supplied charging case and close the cover. 2 Plug the travel adapter into the case's charging socket. 3 Plug the travel adapter into the electrical outlet. • For Set 1, use the travel adapter provided. • Charge the headset until the red light on the headset turns to blue. • The headset will be fully charged in approximately 2 hours. 4 Remove the travel adapter from the case. NOTE: The headset cannot be used while charging. Test and use Your phone and headset are now paired and ready to make and receive calls. To confirm they are operating properly, make a call: 1 Place the headset over your ear. See Wearing the headset on the reverse side of this guide. 2 On your phone, make a call to the number you want. 3 If your phone and headset are successfully paired, you will hear ringing on the headset. After you have successfully paired your phone and headset, you do not need to repeat these initial setup steps each time you use the headset. Using your WEP200 See Features and Functions Guide on the reverse side of this guide for information on using your WEP200.