Samsung WEP210 Quick Start Guide - Page 1

Quick Start Guide Samsung Bluetooth® Headset WEP210 Get connected in 4 quick steps Charge your headset Put your headset in pairing mode Turn on Bluetooth on your phone and pair with headset Test and use Start here Headquarters: 1301 East Lookout Drive Suite 150 Richardson, TX 75082 Internet Address: http://www.samsungmobileusa.com/ accessories Customer Care Center: 1-888-987-4357 Guide No.: GH68-12949A 11/2006. Rev. 1.0 Before using your headset Thank you for purchasing the Samsung Bluetooth Mono Headset WEP210. We hope you will be delighted with its operation. Take a moment before you get started to familiarize yourself with your new headset. Multi-Function button Indicator light Volume Up button Earpiece Volume Down button Adapter jack Microphone Check the accessories Make sure you have the following items with your headset: Travel Adapter, User's Guide, Earpiece Cover The items supplied with your headset may vary, depending on your country or service provider. • Bluetooth version: 2.0 (compatible with devices of Bluetooth version 1.1 or higher) • Supported Bluetooth Profiles: - Headset Profile - Hands-Free Profile Put your headset in pairing mode Before you can use your headset, you must pair it with your phone. 1 Ensure that the headset is off (see Turn headset on/off on the reverse side of this guide). 2 Press and hold the Multi-Function button until the blue indicator light stays on after blinking. Turn on Bluetooth on your phone and pair with headset 1 Set your Bluetooth phone to discover the headset by following your phone's guide. Typically, the steps involve going to the Settings, Connection, or Bluetooth menu on your phone and then selecting the option to discover Bluetooth devices. Your phone will find the Samsung WEP210 headset and ask if you want to pair with it. Confirm this by pressing the Yes or OK key. 2 Enter a passkey or PIN, 0000 (4 zeros), then press the Yes or OK key. Charge your headset Charge the headset's battery fully before using the headset for the first time. 1 Plug the travel adapter into the jack on the headset. 2 Plug the travel adapter into the electrical outlet. • Charge the headset until the red light on the headset turns to blue. • The headset will be fully charged in approximately 2 hours and 30 minutes. 3 Remove the travel adapter from the headset. • The headset cannot be used while charging. • Use only a Samsung-approved charger or adapter. Test and use Your phone and headset are now paired and ready to make and receive calls. To confirm they are operating properly, make a call: 1 Place the headset over your ear. See Wear the headset on the reverse side of this guide. 2 On your phone, make a call to the number you want. 3 If your phone and headset are successfully paired, you will hear ringing on the headset. After you have successfully paired your phone and headset, you do not need to repeat these initial setup steps each time you use the headset. Using your WEP210 See Features and Functions Guide on the reverse side of this guide for information on using your WEP210.