Samsung WF405ATPASU/AA Trouble Shooting Guide User Manual Ver.1.0 (English, Fr - Page 18
No Key Operation, Will Not Drain
![]() |
View all Samsung WF405ATPASU/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
TROUBLE SHOOTING WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. TROUBLE DIAGNOSIS • Read Lock Switch and PCB (CN2 & CN3). (Refer to PCB Connector Check.) • Perform Quick Test Mode. Check Door Lock. Check the output voltage of Door Lock Coil. If it reads 120V, change Door Lock Switch, and if not, change PCB. (Refer to PCB Connector Check.) No Key Operation • Option and Function buttons respond differently according to each cycle. • Child Lock is being activated. To exit, hold down Soil Level Key and Signal Key simultaneously until it sends out a beeping sound. • When "End" illuminates on the display, only Power button works. Press Power button and make new cycle selections. Will Not Drain • Check for any kink on the drain hose. If any, straight it out. • Check for any restriction in the drain hose. • Close the door and press the Start/Pause Button. For safety reasons, the washer does not tumble or spin with the door open. • When it is freezing outside, check if it is frozen inside the drain hose. • Check if the water level signal input is correct. Go to Board Input Test Mode. • Go to Quick Test Mode and do Drain Pump Test. • Check if there is any twist in the hose (the one between Tub and Drain Pump). • Check if it reads AC 120V at the pump when a spin cycle is selected. • Read the winding resistance of the pump motor. (14.2±7% Ohms) • Check the pump at CN3(PIN3) on PCB. It should read AC 110~120V. (Refer to PCB Connector Check) 18 WF405ATP-03144A_EN.indd 18 2012-03-02 �� 9:28:50
![](/manual_guide/products/samsung-wf405atpasuaa-trouble-shooting-guide-user-manual-ver10-english-french-bac71c1/18.png)