Samsung WF42H5200AW/A2 User Manual Ver.0 (English, French, Spanish) - Page 15
Important Note To Installer - washing machine
View all Samsung WF42H5200AW/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
01 Installing your washer Important note to installer Please read the following instructions carefully before installing the washer. These instructions should be retained for future reference. We recommend you hire a professional to install this washer. Installation flow chart Selecting a location Removing the shipping bolts (*Drum only) Connecting the water and the drain Please check again before steps. Adjusting the levelling feet Powering your washing machine [Running a test cycle] Run a test cycle (Rinse+Spin) with small amount of laundary (about 4~5 Towels) Does your washer have excess vibration Yes or noise? Running a Calibration mode (Refer to the following No description) Finish the installation STEP 1 Removing the Shipping Bolts Before using your washer, you must remove all shipping bolts from the back of the unit. 1. Loosen all the bolts with the supplied wrench. 2. Slide the bolt and spacer up and remove the bolt with the spacer through the hole in the rear wall of your washer. Repeat for each bolt. 3. Cover the holes with the supplied Bolt Hole Covers (See page 11). 4. Keep the shipping bolts and spacers for future use. STEP 2 Selecting a Location Before you install your washer, make sure the location: • Has a hard, level surface. • Is away from direct sunlight. • Has adequate ventilation. • Will not freeze (tempuratures are never below 32 °F or 0 °C). • Is away from heat sources such as oil or gas. • Has enough room for the power cord. • Doesn't have any carpeting that will obstruct ventilation openings. #&55&3@8 JOEE English _15