Sanyo DP26671 Owners Manual - Page 37

ENGLISH Connections to other equipment To connect the TV to a PC (Personal Computer) NOTE: Before connecting any cables, disconnect the AC Power Cords of both the TV and Personal Computer from the AC outlets. 1 Connect an RGB cable from the monitor output (a) on your PC to the RGB connector on the TV and tighten the screws. (Monitor Cable not supplied.) NOTE: If Computer has only DVI Output (b), a DVI to RGB converter will be required (converter not included). 2 Insert one end of a Stereo Mini-Audio cable into the PC Audio Out jack and the other end into the PC/DVI AUDIO Input jack. (Stereo Mini-Audio Cable not supplied.) HINT: Volume can be adjusted both from the PC and the TV VOL +/-. 3 Press the INPUT SELECT on your Remote Control to step through signal inputs to select PC. 4 Press the SETUP/TV MENU to display the TV's PC Setting Menu. Select "Auto Adjust". NOTE: Power on the TV and any other peripheral equipment before powering on the computer. (a) RGB (b) DVI JACK Rear of the unit VGA cable (not supplied) Audio cord (not supplied) NOTE: • Save and close all documents, in case computer might need to be restarted. • Before connecting your computer to your TV, please refer to the following chart to set to a compatible resolution. • A Refresh Rate value of 60 Hz on your computer is recommended for your TV. RESOLUTION 640 x 480 720 x 400 800 x 600 1024 x 768 1280 x 768 1280 x 720 1360 x 768 ASPECT RATIO 4:3 18:10 4:3 4:3 15:9 16:9 16:9 REFRESH RATE (Hz) 60 72 75 70 56 60 72 75 60 60 60 60 HORIZONTAL FREQUENCY (kHz) 31.47 37.86 37.50 31.47 35.16 37.88 48.08 46.88 48.36 47.78 45.00 47.71 VERTICAL FREQUENCY (Hz) 59.94 72.81 75.00 70.00 56.25 60.32 72.19 75.00 60.00 59.87 60.00 60.00 56Q0221A_eng.indd 37 37 1/13/11 2:25:00 PM