Sanyo DP50710 Owners Manual - Page 5

STAND REMOVAL 1 Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish 2 Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw. STAND ASSEMBLY ___________ 1 Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish 2 Carefully insert the stand base to the bottom of the HDTV and secure the base by inserting 4 screws as indicated in the above diagram. NOTE: If your HDTV came packed with the Stand Base unassembled, these screws will be found in the literature package. WALL MOUNTING Wall mounting of the HDTV must be performed by a skilled person. Use the screws that are threaded into four (4) of the six (6) inserts on the back of your Plasma HDTV to secure it to a wall mounting kit (not included.) VESA standard interface: 480 x 200 and 480 x 360 Mounting screws measurements: M6 (6mm) Diameter, Length-12mm (maximum) GETTING STARTED BATTERY INSTALLATION Install two (2) "AAA" batteries in the remote control. (Not included) To ensure safe operation, please observe the following precautions: • Replace both batteries at the same time. Do not use a new battery with a used battery. • There's a risk of explosion if a battery is replaced by an incorrect type. • Do not expose the Remote Control unit to moisture or heat. • Be sure to match the "+" and "-" signs on the batteries with marks inside the remote control. ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE Hook up your antenna or your cable service to the HDTV's ANT terminal with the use of a 75 OHM coaxial cable. NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment. ANTENNA CABLE ANALOG / DIGITAL ANTENNA IN The tuner in this HDTV can receive: • Digital and Analog off air signals from an antenna • Analog or ClearQAM cable channels from a direct Cable TV connection. Need help? www.sanyoctv.com 1-800-877-5032 5