Sanyo EM-U1000W Service Manual - Page 14
The Capacitor, The Diod - parts
UPC - 086483046926
View all Sanyo EM-U1000W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1. Assemble the fan motor as FIG.4 - 14. Drip the glue on the "★"place of the fan motor shaft, and fix the fan on the motor, make sure it must be fixed to the bottom of the shaft. Attention: The fan motor shaft should not be curved, the fan should have no abnormal stick up. After assembled, check whether the running fan would knock the fan holder. 2. Assemble the fan holder as FIG.4 - 13, Then connect the power supply cord with the two wires of the fan motor, and tighten the screws as FIG.4 - 11 and FIG.4 - 12. fuse housing earthing screw power supply cord Fig.4-12 fan motor back board fan Fig.4-13 Fig.4-14 screw 1.11 THE CAPACITOR Firstly, do as the 1, 2, and 3, steps of Ⅲ of this part. To disassemble, 1. Pull the wires of the capacitor out (4-15). 2. Loosen and take out the screw which fix the capacitor clip with a "+" - screwdriver, and take out the clip and the capacitor. (4-15). To assemble, 1. Place the capacitor in the capacitor clip with the end which has three foot near the diode (4-16). 2. Insert one end of the clip in the fan holder trough (FIG.4-15). 3. Tighten the screw, which fix the capacitor clip. 4. Plug in all the plugs of the capacitor. capacitor diode Fig.4-15 fan holder screw 1.12 THE DIOD Firstly, do as the 1, 2, and 3 steps of Ⅲ of this part. To disassemble, 1. Pull out the diode plug, which plugged in the capacitor. 2. Loosen the screw, which fixed the diode, and take the diode off. To assemble, magnetron transformer 12 H.V.fuse capacitor Fig.4-16 diode