Sanyo PDG-DHT8000L Owners Manual Network set up - Page 51

Use of telnet 3. When communication is established correctly, the word "PASSWORD:" appears on the window. Type the login password (Network PIN code*2) for the projector and then press "Enter" key on the keyboard. If you do not set up the Network PIN code, just press "Enter" key. When the word "Hello" is replied, login has been succeeded. * The password "1234" is used for the example. 4. Type the commands, refer to below table, to control the projector and then press "Enter" key for termination. For example, type "C00" which is a command to turn on the projector, and press "Enter" key. Confirm the projector is turning on. * Enter with ASCII 64-byte capital characters and one-byte characters. To disconnect the communication, press "Ctrl" key and "]" key at the same time, type "close" and then press "Enter" key on the Keyboard. > close [return] The table below shows the typical command lists for controlling this projector and please consult your local dealer for further information of another commands. Command list table Command Function C00 Power on C01 Power off C05 Select Input 1 C06 Select Input 2 C07 Select Input 3 C08 Select Input 4 C1C Menu display on C1D Menu display off *1 F urther instructions about the telnet application, please see the on-line guide on your computer. *2 The password is a Network PIN code decided item "Network PIN code setting" (☞pp.15, 23). If the authentication of the entered password is failed 4 times continuously, the communication will be disconnected automatically. Please try again for the connection. ✐ If the password or any command is not entered for more than 30 seconds, the communication will be disconnected automatically. Please try again for the connection. (☞p.50) Windows : Press any key and then type at "Microsoft Telnet > ". MAC : Type "telnet" [return] and then type at "telnet> ". 51 ENGLISH