Sanyo PDG-DHT8000L RS232C Basic - Page 8

PDG-DHT8000L Basic Serial Command Functional Specifications 6.4 Operation Requirements When the projector is in the status below, Functional Execution Commands are limited. (Status Read Commands are available in following status) Projector Status Available Functional Execution Commands In Standby status C00: POWER ON Count Down in process C00: POWER ON (Countdown is terminated) Cooling Down in process NONE (No Execution) Cooling Down in process due to abnormal temperature NONE (No Execution) In Abnormal Temperature NONE (No Execution) In Abnormal Power Status NONE (No Execution) On switching modes NONE (No Execution) Power Saving Cooling Down in process NONE (No Execution) In Power Saving status C00: POWER ON C01: POWER OFF Note) In the above status, it returns [ACK] [CR] even if the projector receives other commands, 6.5 POWER ON Command COMMAND "C00" [CR] Detail Power ON When already Power is ON, no operation starts. When sending this command during Count Down in process, Count Down process is terminated. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.6 POWER OFF Command (Immediate POWER OFF) COMMAND "C01" [CR] Detail Power OFF (Standby) When Power is turned OFF with ON/STAND-BY button of the projector and remote control, "Power OFF" is displayed. In contrast, this command executes immediately Power OFF. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.7 INPUT 1 Command COMMAND "C05" [CR] Detail Select Input 1 Note) When there is no board inserted to Input 1, it is not executed. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 8/23