Sanyo PLC-XU101 User Manual - Page 47

Setting Remote control This projector provides two different remote control codes; the factory-set, initial code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time. When operating the projector in "Code 2", both the projector and the remote control must be switched to "Code 2". To change the code for the projector; Select either "Code 1" or "Code 2" in this Setting Menu. To change the code for the remote control; Press and hold both the MENU and IMAGE buttons together for 10 seconds or more. After changing the code, make sure the remote control operates properly. ✔Note: If the batteries are removed from the remote control for a long period of time, the remote control code will be reset. Remote control Press and hold MENU and IMAGE buttons for 10 seconds or more. Security (Key lock and PIN code lock settings) This function allows you to use Key lock and PIN code lock function to set the security for the projector operation. Key lock This function locks operation of the top control or the remote control. It is useful to prevent operation by an unauthorized person. ···· not locked. ···· lock the operation of the top control. To unlock, use the remote control. ···· lock the operation of the remote control. To unlock, use the top control. If the top control accidentally becomes locked and you do not have the remote control nearby or there is something wrong with your remote control, contact the dealer where you purchased the projector or the service center. Key lock Select Key lock. Choose one of the alternatives with the Point ed buttons and select [Yes] to activate it. 47