Sanyo VCC-N6584 Instruction Manual, VCC-N6584P - Page 6
Parts Names and Functions
UPC - 086483072697
View all Sanyo VCC-N6584 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Parts Names and Functions ■ Rear ᶄ ᶃ ᶇ ᶆ ᶅ AC24V -DC12V -- ALARM OUT POWER VIDEO OUT ALARM IN GND LINK CLASS 2 WIRING COM LAN ᶈ ᶉ ᶊ ᶋ ᶃ Flange back fixing screw ᶄ Flange back adjustment lever ᶅAC24V / DC12V terminals Connect this terminal to the power supply. • When the camera is turned on, the POWER lamp lights. ᶆPower lamp ᶇ Lens terminals ᶈVIDEO OUT connector (BNC type) Used to output image signals. Connect to video equipment such as a monitor. ᶉControl terminals When connecting the cable, press and hold down the protrusion of the terminal, insert the cable into the terminal, and then release the protrusion. • COM terminal (Earth terminal) • ALARM IN terminal Connect to a device such as an external alarm switch or an infrared sensor. • ALARM OUT terminal Used to connect to an external buzzer or lamp. When an alarm is detected, the device connected to the terminal notifies that an alarm is detected. ᶊLAN connector (RJ-45) Used to connect the camera to your network. ᶋLINK lamp When connected correctly to the network, the lamp will illuminate 3 seconds after the power is turned on. Flashes while data is being transferred. ■ Side ᶃ ᶃ Camera setting switches (P7) ᶄᶅ ᶄ White balance manual adjustment controls R: Red adjustment B: Blue adjustment ᶆ ᶅ Iris adjustment control (LEVEL) This can only be adjusted when using a DC- type automatic iris lens. ᶆ Reset button (RESET) If pressed for approximately 5 seconds, it initializes the various NETWORK SETTINGS settings (such as IP address) for network operations. 5