Sanyo WXU700 Instruction Manual, PLC-WXU700 - Page 17
Connecting to a Computer, Cables used for connection
UPC - 086483074219
View all Sanyo WXU700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Connecting to a Computer Cables used for connection • VGA cables (Mini D-sub 15 pin) * • USB cable • Audio cables • HDMI-DVI cable (*One cable is supplied; other cables are not supplied with the projector.) Installation Audio Output Monitor Output Monitor Output / Monitor Input DVI Output External Audio Equipment USB cable VGA cable VGA cable HDMI-DVI cable Audio cable (stereo) USB COMPUTER IN 1 COMPUTER IN 2 / COMPONENT MONITOR OUT HDMI This terminal is switchable. Set up the terminal as COMPUTER IN 2 or MONITOR OUT.(See Page 53.) Audio Input Audio cable (stereo) COMPUTER 1 COMPONENT/ COMPUTER 2 AUDIO IN AUDIO OUT (stereo) Note: • Input sound to the COMPUTER1 COMPONENT/COMPUTER 2 AUDIO IN terminal when using the COMPUTER IN 1/ COMPONENT IN and the COMPUTER IN 2/MONITOR OUT terminal as input. • When the AUDIO OUT is plugged-in, the projector's built-in speaker is not available. • USB cable connection is needed when operating the computer with the remote control or using the PAGE ▲▼ buttons on the remote control. • When the cable is of the longer variety, it is advisable to use the COMPUTER IN 1 / COMPONENT IN and not the COMPUTER IN 2. Note: • Analog RGB and component signals cannot be output from the COMPUTER IN 2/MONITOR OUT terminal when using the COMPUTER IN 2/MONITOR OUT terminal as output. • When DVI signal is connected to HDMI terminal with HDMI-DVI cable, connect the sound signal to COMPUTER 2 AUDIO IN and set up Sound of "HDMI setup" to "Computer2". (p.53) Unplug the power cords of both the projector and external equipment from the AC outlet before connecting cables. 17