Sanyo XU33 Instruction Manual, PLC-XU33 - Page 37
Appendix, Caution - plc lamp
View all Sanyo XU33 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
APPENDIX LAMP REPLACEMENT LAMP REPLACE When the life of the Projection Lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly. This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly. ON -- OFF TOP CONTROL RLEAPMLPACE WATRENMIPN.G VOLUME - INPUT IMAGE MENU Allow a projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of a projector can become very hot. CAUTION For continued safety, replace with a lamp assembly of the same type. Do not drop a lamp assembly or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp assembly. 1 Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes. 2 To remove Lamp Cover, remove the screw with a screwdriver. 3 Loosen 3 screws with a screwdriver and pull out Lamp Assembly by grasping Handle. 4 Replace Lamp Assembly with a new one and tighten 3 screws back into position. Make sure that Lamp Assembly is set properly. Replace Lamp Cover and tighten the screw. 5 Connect AC Power Cord to the projector and turn on the projector. 6 Reset the Lamp Replace Counter. Refer to "LAMP REPLACE COUNTER" on the next page . LAMP COVER SCREW LAMP ASSEMBLY SCREW HANDLE ORDER REPLACEMENT LAMP Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer. G Model No. of your projector : G Replacement Lamp Type No. : PLC-XU33 / PLC-XU38 POA-LMP35 (Service Parts No. 610 293 2751) 37