Schwinn 170 Journey 1.5 Upright Bike Assembly and Owner's Manual - Page 34
Condition/Problem, Things to Check, Solution
View all Schwinn 170 Journey 1.5 Upright Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Condition/Problem Console shuts off (enters sleep mode) while in use Unit rocks/does not sit level Pedals loose/unit difficult to pedal Clicking sound when pedaling Seat post movement Things to Check Check Speed Sensor (requires shroud removal) Check electrical (wall) outlet Check connection on console Check data cable integrity Check data cable connections/orientation Reset Machine Check magnet position (requires shroud removal) Check Speed Sensor (requires shroud removal) Check leveler adjustment Solution Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Make sure unit is plugged into a functioning wall outlet. Connection should be secure and undamaged. Replace adapter or connection at unit if either are damaged. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. Magnet should be in place on pulley. Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Adjust levelers until bike is level. Check surface under unit Check pedal to crank arm connection Check crank arm to axle connection Check pedal to crank arm connection Check locking pin Check adjustment knob Adjustment may not be able to compensate for extremely uneven surfaces. Move bike to level area. Pedal should be tightened securely to crank. Insure connection is not cross-threaded. Crank should be tightened securely to axle. Be sure cranks are connected at 180 degrees from each other. Remove pedals and reattach. Be sure adjustment pin is locked into one of the seat post adjustment holes. Be sure knob is securely tightened. 34