Schwinn 470i Elliptical Assembly and Owner's Manual - Page 46
workout continues
View all Schwinn 470i Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Condition/Problem Drive train click/tick noise once per full crank revolution Squeaking noise that appears a few minutes into a workout and normally will get progressively worse as workout continues Things to Check Solution Check crank/pulley assembly Disconnect left and right foot assemblies and rotate crank. If sound persists, replace crank/pulley assembly. If sound does not come from rotating crank, check foot assemblies and upper/ lower handlebars. Check foot assemblies, leg Manually move foot, leg, and handlebar assemblies to isolate assemblies, handlebar sound. Replace part making sound. assemblies Bolt that connects the Loosen pivot rod bolt slightly until noise goes away. White lithium swing arms to the axle run- grease can also be applied for a temporary fix. Contact your local ning through the console distributor for further assistance.. mast 46