Schwinn World Adventure Schwinn Owner's Manual - Page 40
Linear Pull Brakes
View all Schwinn World Adventure manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Cable adjusƟng barrel Handlebar Noodle Grip Brake lever Cable head Ferrule 3.31 Linear Pull Brakes If the brake cable is not connected at the brake lever, slide the head of the brake cable into the brake lever per the diagram, and thread the cable through the slot in the brake lever so the cable end rests squarely in the adjustment barrel or cable end rests in the recess of the brake lever. (Fig. 3.31) If the brake cable is disconnected at the brake arm, with left hand, squeeze the 2 brake halves together until the brake pads touch the rims. With your right hand pull the brake cable so that the stepped end of the "noodle" can be inserted into the brake carrier. Brake adjustment Check to be sure the cable is seated in the brake lever. Loosen the cable anchor bolt just enough to allow the cable wire to move freely. With your left hand squeeze the caliper brake until both brake pads contact the rim. While holding the brake closed with your left hand, use your right hand to pull the brake cable tight (through the cable anchor. Again inspecting that the cable end is seated in the brake lever, and the barrel adjuster of the brake. Tighten the cable anchor as much as you can by hand, and then while still squeezing the brake, tighten the cable anchor fully with a wrench. (Fig. 3.32) ASSEMBLY 3.32 40 ©2010