Seagate Barracuda Green Product Manual - Page 26
Supported ATA commands
View all Seagate Barracuda Green manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Serial ATA Interface www.seagate.com Table 5 Serial ATA connector pin definitions (Continued) Segment Pin Function Definition P1 V33 P2 V33 P3 V33 P4 Ground 3.3V power 3.3V power 3.3V power, pre-charge, 2nd mate 1st mate P5 Ground 2nd mate P6 Ground 2nd mate Power P7 V5 P8 V5 P9 V5 P10 Ground 5V power, pre-charge, 2nd mate 5V power 5V power 2nd mate P11 Ground or LED signal If grounded, drive does not use deferred spin P12 Ground 1st mate. P13 V12 P14 V12 P15 V12 12V power, pre-charge, 2nd mate 12V power 12V power Notes: 1. All pins are in a single row, with a 1.27mm (0.050") pitch. 2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are: • the ground pins P4 and P12. • the pre-charge power pins and the other ground pins. • the signal pins and the rest of the power pins. 3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. 4. All used voltage pins (Vx) must be terminated. 4.3 Supported ATA commands The following table lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA commands, refer to the Serial ATA International Organization: Serial ATA Revision 3.0 (http://www.sata-io.org). See "S.M.A.R.T. commands" on page 34 for details and subcommands used in the S.M.A.R.T. implementation. Table 6 Supported ATA commands Command name Command code (in hex) Check Power Mode Device Configuration Freeze Lock Device Configuration Identify E5H B1H / C1H B1H / C2H 26 Barracuda Green SATA Product Manual, Rev. A