Seagate ST1000LM014 Momentus XT (Gen2) Product Manual - Page 26
Drive mounting
View all Seagate ST1000LM014 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
4.4 Drive mounting You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See Figure 3 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive: • Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling. • Use only M3 UNC mounting screws. • Do not overtighten the mounting screws (maximum torque: 4.0 inch-lb). • Four (4) threads (0.080 inches) minimum screw engagement recommended. Measurements shown in Figure 3 are in inches. Figure 3. Mounting dimensions-top, side and end view 20 Momentus XT Product Manual, Rev. D
20
Momentus XT Product Manual, Rev. D
4.4
Drive mounting
You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting
holes. See Figure 3 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:
•
Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
•
Use only M3 UNC mounting screws.
•
Do not overtighten the mounting screws (maximum torque: 4.0 inch-lb).
•
Four (4) threads (0.080 inches) minimum screw engagement recommended.
Measurements shown in Figure 3 are in inches.
Figure 3. Mounting dimensions—top, side and end view