Seagate ST1000NM0053 Constellation ES SATA Product Manual - Page 33
Drive mounting
View all Seagate ST1000NM0053 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
4.4 Drive mounting You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See Figure 5 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive: • Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling. • Use only 6-32 UNC mounting screws. • The screws should be inserted no more than 0.150 in (3.81mm) into the bottom or side mounting holes. • Do not overtighten the mounting screws (maximum torque: 6 in-lb). Note. These dimensions conform to the Small Form Factor Standards documented in SFF-8301 and SFF-8323, found at www.sffcommittee.org in mm Breather Hole in mm Figure 5. Mounting dimensions-top, side and end view Constellation ES Serial ATA Product Manual, Rev. G in mm 27