Seagate ST300MM0026 Savvio 10K.3 SAS Product Manual - Page 61
Warning., Table 7, Supported commands
View all Seagate ST300MM0026 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Table 7: Supported commands Command name Verify (12) Verify (16) Verify (32) Write (6) Write (10) DPO bit FUA bit Write (12) Write (16) Write (32) Write and Verify (10) DPO bit Write and Verify (12) Write and Verify (16) Write and Verify (32) Write Buffer (modes 0, 2, supported) Write Buffer Firmware Download option (modes 5, 7, Ah and Bh) [3] Firmware Download option (modes 4, 5, 7) Write Long (10) Write Long (16) Write Same (10) [5] PBdata LBdata Write Same (16) [5] Write Same (32) XDRead XDWrite XPWrite Command code AFh AFh 7Fh/000Ah 0Ah 2Ah AAh 8Ah 7Fh/000Bh 2Eh AEh 8Eh 7Fh/000Ch 3Bh 3Bh 3Fh 9Fh/11h 41h 93h 7Fh/000Dh 52h 50h 51h Supported N N N Y Y Y Y N N N Y Y N N N Y (non-SED drives only) Y (non-SED drives only) Y (SED drives only) Y N Y N N N N N N N [1] Savvio drives can format to 512, 520, or 528 bytes per logical block. [2] Warning. Power loss during flash programming can result in firmware corruption. This usually makes the drive inoperable. [3] Reference Mode Sense command 1Ah for mode pages supported. [4] Y = Yes. Command is supported. N = No. Command is not supported. A = Support is available on special request. [5] Approximately 1.5 increase in time to complete this command for a SED drive versus a non-SED drive of the same capacity. Savvio 10K.3 SAS Product Manual, Rev. J 53