Seagate ST300MP0004 Savvio 15K.3 SAS Product Manual - Page 34
General DC power requirement notes., Conducted noise immunity, Power sequencing
View all Seagate ST300MP0004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
General DC power requirement notes. 1. Minimum current loading for each supply voltage is not less than 1.7% of the maximum operating current shown. 2. The +5V and +12V supplies should employ separate ground returns. 3. Where power is provided to multiple drives from a common supply, careful consideration for individual drive power requirements should be noted. Where multiple units are powered on simultaneously, the peak starting current must be available to each device. 4. Parameters, other than spindle start, are measured after a 10-minute warm up. 5. No terminator power. 7.3.1 Conducted noise immunity Noise is specified as a periodic and random distribution of frequencies covering a defined frequency range. Maximum allowed noise values given below are peak-to-peak measurements and apply at the drive power connector. +5V +12V = 250 mV pp from 100 Hz to 20 MHz. = 450 mV pp from 100 Hz to 100 KHz. 250 mV pp from 100 KHz to 20 MHz. 150 mV pp from 20 MHz to 100 MHz. 7.3.2 Power sequencing The drive does not require power sequencing. The drive protects against inadvertent writing during power-up and down. 26 Savvio 15K.3 SAS Product Manual, Rev. E