Seagate ST310014ACE Product Manual - Page 24
Jumper settings, Master/slave configuration
![]() |
View all Seagate ST310014ACE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
16 ST310014ACE Product Manual, Rev. B 2.2 Jumper settings 2.2.1 Master/slave configuration The options jumper block shown in Figure 2 is used to configure the drive for operation. It is the 8-pin dual header between the interface connector and the power connector. Use the following settings to configure the drive as a master or a slave. Master or single drive. The drive is configured at the factory for a master or single-drive operation with a jumper set on pins 7 and 8. Drive as slave. Remove all jumpers. Drive as master with a non-ATA-compatible slave. Set a jumper on pins 5 and 6 and a jumper on pins 7 and 8. Use this jumper setting only if the drive does not work as a master with no jumpers installed. Options jumper block Master or single drive Drive is slave Master with non ATAcompatible slave Cable select 7531 8642 Figure 2. Master/slave jumper settings Circuit Board
![](/manual_guide/products/seagate-st310014ace-product-manual-d2221e6/24.png)