Seagate ST32000647NS Constellation ES.2 SAS Product Manual - Page 45
Authenticated firmware download, Power requirements, Supported commands, RevertSP
View all Seagate ST32000647NS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
9.7 Authenticated firmware download In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: 1. The download must be an SED file. A standard (base) drive (non-SED) file will be rejected. 2. The download file must be signed and authenticated. 3. As with a non-SED drive, the download file must pass the acceptance criteria for the drive. For example it must be applicable to the correct drive model, and have compatible revision and customer status. 9.8 Power requirements The standard drive models and the SED drive models have identical hardware, however the security and encryption portion of the drive controller ASIC is enabled and functional in the SED models. This represents a small additional drain on the 5V supply of about 30mA and a commensurate increase of about 150mW in power consumption. There is no additional drain on the 12V supply. See the tables in Section 7.3 for power requirements on the standard (non-SED) drive models. 9.9 Supported commands The SED models support the following two commands in addition to the commands supported by the standard (non-SED) models as listed in Table 6: • Security Protocol Out (B5h) • Security Protocol In (A2h) 9.10 RevertSP The SED models will support RevertSP feature where it erases all data in all bands on the device and returns the contents of all SPs (Security Providers) on the device to their Original Factory State. Constellation ES.2 SAS Product Manual, Rev. C 37