Seagate ST320LT014 Momentus Thin (4K) SATA Product Manual - Page 15
Typical current profile, Deferred spinup, Conducted noise, Voltage tolerance
View all Seagate ST320LT014 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3.9.1.1 Typical current profile Figure 1. Typical +5V only startup and operation current profile 3.9.2 Deferred spinup Momentus Thin drives do not support the deferred spinup option. If you require this option, refer to the Momentus 5400.3 SATA Blade Server family of drives. 3.9.3 Conducted noise Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +5 volt line. Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 30 MHz. Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. 3.9.4 Voltage tolerance Voltage tolerance (including noise): 5V ± 10% Momentus Thin Product Manual, Rev. C 9