Seagate ST3320413AS Barracuda 7200.10 PATA Product Manual - Page 30
Typical current profile, Conducted noise, Note.
View all Seagate ST3320413AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
2.8.1.1 Typical current profile Figure 1 Typical 5V startup and operation current profile Figure 2 Typical 12V startup and operation current profile 2.8.2 Conducted noise Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on the +12 volt line or an equivalent 15-ohm resistive load on the +5 volt line. • Using 12-volt power, the drive is expected to operate with a maximum of 120 mV peak-to-peak square-wave injected noise at up to 10 MHz. • Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 10 MHz. Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. 24 Barracuda 7200.10 PATA Product Manual, Rev. F