Seagate ST4000NM0053 Constellation ES.1 SAS Product Manual - Page 78
Signal characteristics
View all Seagate ST4000NM0053 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
12.4.6 SAS transmitters and receivers A typical SAS differential copper transmitter and receiver pair is shown in Figure 19. The receiver is AC coupling to eliminate ground shift noise. TX T 100 T l TM 01 X 100 01 Figure 19. SAS transmitters and receivers 12.4.7 Power The drive receives power (+5 volts and +12 volts) through the SAS device connector. Three +12 volt pins provide power to the drive, 2 short and 1 long. The current return for the +12 volt power supply is through the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins. Three +5 volt pins provide power to the drive, 2 short and 1 long. The current return for the +5 volt power supply is through the common ground pins. The supply current and return current must be distributed as evenly as possible among the pins. Current to the drive through the long power pins may be limited by the system to reduce inrush current to the drive during hot plugging. 12.5 Signal characteristics This section describes the electrical signal characteristics of the drive's input and output signals. See Table 15 for signal type and signal name information. 12.5.1 Ready LED Out The Ready LED Out signal is driven by the drive as indicated in Table 16. Table 16: Ready LED Out conditions Normal command activity Ready LED Meaning bit mode page 19h Spun down and no activity Spun down and activity (command executing) Spun up and no activity Spun up and activity (command executing) Spinning up or down Format in progress, each cylinder change LED status 0 1 Off Off On On On Off Off On Blinks steadily (50% on and 50% off, 0.5 seconds on and off for 0.5 seconds) Toggles on/off 70 Constellation ES.1 SAS Product Manual, Rev. E