Seagate ST91000642SS Constellation.2 SATA Product Manual - Page 22
S.M.A.R.T. Read Data Reports
View all Seagate ST91000642SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Power Condition Name Idle_a Idle_b Idle_c Standby_z Power Condition ID 81H 82H 83H 00H Description Reduced electronics Heads unloaded. Disks spinning at full RPM Heads unloaded. Disks spinning at reduced RPM Heads unloaded. Motor stopped (disks not spinning) Each power condition has a set of current, saved and default settings. Default settings are not modifiable. Default and saved settings persist across power-on resets. The current settings do not persist across power-on resets. At the time of manufacture, the default, saved and current settings are in the Power Conditions log match. PowerChoice is invoked using one of two methods • Automatic power transitions which are triggered by expiration of individual power condition timers. These timer values may be customized and enabled using the Extended Power Conditions (EPC) feature set using the standardized Set Features command interface. • Immediate host commanded power transitions may be initiated using an EPC Set Features "Go to Power Condition" subcommand to enter any supported power condition. Legacy power commands Standby Immediate and Idle Immediate also provide a method to directly transition the drive into supported power conditions. PowerChoice exits power saving states under the following conditions • Any command which requires the drive to enter the PM0: Active state (media access) • Power on reset PowerChoice provides the following reporting methods for tracking purposes Check Power Mode Command • Reports the current power state of the drive Identify Device Command • EPC Feature set supported flag • EPC Feature enabled flag is set if at least one Idle power condition timer is enabled Power Condition Log reports the following for each power condition • Nominal recovery time from the power condition to active • If the power condition is Supported, Changeable, and Savable • Default enabled state, and timer value • Saved enabled state, and timer value • Current enabled state, and timer value S.M.A.R.T. Read Data Reports • Attribute 192 - Emergency Retract Count • Attribute 193 - Load/Unload Cycle Count 16 Constellation.2 Serial ATA Product Manual, Rev. F