Sealey LED3601R Instruction Manual - Page 1

360° 3W COB + 1W LED RECHARGEABLE INSPECTION LAMPS LITHIUM-POLYMER MODEL NO: LED3601.V3 SERIES Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE. Refer to instructions 1. SAFETY 9 Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or damaged DO NOT use. 9 Ensure the lamp is fully charged before initial use. 8 DO NOT charge in damp conditions. 8 DO NOT turn the lamp on when it is being charged. 8 DO NOT shine directly into your, another person's or an animal's eyes. 8 DO NOT allow children to use the lamp. 8 DO NOT handle or move the lamp whilst it is being charged. 8 DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged. 8 DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use. 8 DO NOT attempt to open, disassemble, modify or service the battery pack. 8 DO NOT crush, puncture, short external contacts or dispose of in fire or water. 8 DO NOT expose to temperatures above 60°C (140°F). 9 Replace only with the battery pack designated for this product. 9 Recycle or dispose of used battery as stipulated by local regulation. ‰ If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention. 2. INTRODUCTION Mini, lightweight lamp with exclusive patented design owned and registered to Sealey. Unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. Featuring a super bright 3W COB LED light source, which gives an even and constant spread of light. Produces up to 300 lumens with a CRI-80 rating. Recessed lens for added protection. 1W High power LED located in top of the lamp for directional torch use, produces up to 100 lumens. Rubber covered magnet in base and swivel hook for hands-free operation. Hook doubles as pocket/belt clip for easy carrying when not in use. High quality rechargeable 3.7V 1.5Ah li-polymer battery for longer life, no memory effect and a much slower discharge than traditional Ni-MH batteries. Micro USB charging port. Supplied with USB cable. 3. SPECIFICATION Model No LED3601 Series Battery 3.7V 1.5Ah Li-Poly LED Quantity 1 COB + 1 LED Lumen Output Side/Top 300/100lm CRI Rating 80 Operating Time Side/Top 2/6hr Charging Time 3hr IP Rating IP20 Minimum Length 160mm Maximum Length 170mm The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time. We will provide warranty against mechanical and electrical defect for a period of one year - this DOES NOT cover fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the battery regardless of whether it is less than one year old. NOTE: The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another charge. © Jack Sealey Limited Original Language Version LED3601Series.V3 Issue:2 14/02/20