Sealey TL95 Instruction Manual - Page 2

5.3. Fix the Piezo Clamp (5) onto a straight section of the Injector fuel pipe for the No.1 cylinder as close to the pump as possible in order to get the strongest reading. The Piezo Clamp and fuel pipe should be clean and dry. Make sure that the Piezo Clamp is in full contact with the fuel pipe but DO NOT overtighten as this could cause damage to the sensor within the clamp. 5.4. Take the Sensor Lead and connect the YELLOW clip (8) to one of the adjustable fixings on the clamp and the BLACK clip (7) to the same Injector fuel pipe to which the clamp is connected. ‰ WARNING! Ensure that the Black Sensor clip DOES NOT touch any of the Glow Plugs and associated mountings or wiring as this may cause a short circuit which could disable engine operation and may damage any connected monitoring device. 5.5. Take the Power Lead and connect the RED clamp (2) to the positive side of the vehicle battery and the BLACK clamp (1) to the negative of the battery. Note: The monitoring device used i.e. A Timing Light, Engine Analyzer or Digital Multimeter may also be powered from the vehicle's battery. 5.6. Attach the inductive pickup from your chosen monitoring device e.g. a timing light, onto the Pickup Loop (3) on the converter box. If the timing light inductive pickup has an arrow mark, ensure that the mark is face up when attached to the Pickup Loop. 5.7. Start the engine and allow it to reach operating temperature, then read the results from the timing light. The Indicator Light on the converter box (4) should flash consistently. If the indicator light does not flash, check all the connections or relocate the Piezo Clamp to another section of the fuel pipe. Note: Low vehicle battery, defective Injector Pump, or lack of fuel may prevent the Indicator Light from flashing. OPERATION DIAGRAM ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations. WEEE REGULATIONS Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information. Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 [email protected] www.sealey.co.uk © Jack Sealey Limited Original Language Version TL95 | Issue:3 (1) 08/07/20