Seiko 6R27 Manual - Page 11

English NOTES ON OVERHAUL ● The watch is a precision device with a lot of moving parts lubricated with special oils. If the parts run short of oil or get worn out, the watch may lose time or stop its operation. In such a case, have the watch overhauled. NOTES ON GUARANTEE AND REPAIR ● Please contact the retailer the watch was purchased from or SEIKO CUSTOMER SERVICE CENTER for repair or overhaul. ● Within the guarantee period, please present the certificate of guarantee to receive repair services. ● Guarantee coverage is provided in the certificate of guarantee. Please read carefully and retain it. 20 TROUBLESHOOTING English Problem Possible causes Solutions The watch stops operating. The power supplied by the mainspring has been consumed. Turn the crown or swing the watch to wind it up. The watch will start operating. If the watch does not start, consult the retailer from whom the watch was purchased. Even though you wear The watch is worn on your the watch every day, wrist only for a short period the power reserve indicator of time, or the amount of arm does not move up. movement is small. Wear the watch for an extended period of time, or when taking off the watch, turn the crown to wind the mainspring if the remaining power shown by the power reserve indicator is not sufficient for the next use. The watch gains/loses The watch has been left temporarily. in extremely high or low temperatures for a long time. Normal accuracy will resume when the watch returns to normal temperature. The watch was brought into close contact with a magnetic object. Normal accuracy will resume when the watch is kept away from close contact with the magnetic source. If this condition persists, consult the retailer from whom the watch was purchased. You dropped the watch, hit it against Normal accuracy will not resume. Consult the a hard surface or wore it while retailer from whom the watch was purchased. playing active sports. The watch was exposed to strong vibrations. The watch has not been Consult the retailer from whom the watch was overhauled for more than 3 years. purchased. The day and date change AM/PM is not properly set. at 12 o'clock noon. The glass is blurred and the Water got inside the watch due to blur persists for a long time. the deterioration of the gasket, etc. Advance the hands by 12 hours. Consult the retailer from whom the watch was purchased. * For the solution of troubles other than listed above, contact the retailer from whom the watch was purchased. 21