Seiko Mile Marker Manual - Page 4

English PRECAUTIONS ON USING THE WATCH WITH THE MAP METER/MILE MARKER FUNCTION ● When measuring the distance, trace the route on the map slowly and securely with the driving wheel, taking care not to apply undue force onto the driving wheel. However, if you press the driving wheel down onto the map too lightly, the wheel may slip off from the route. ● Do not use the map meter/mile marker function in sandy or dusty places. ● Your watch is designed to withstand up to 20 bar, however, do not use the map meter/mile marker function in water, as this may damage the driving wheel. When wearing the watch in water, therefore, make sure that the driving wheel is securely locked. ● In order to prevent putting a burden on the stem, keep the driving wheel locked while wearing the watch in normal use. ● The accuracy of indication of distance obtained by the map meter/mile marker function may be affected by the conditions where the measurement is made. Therefore, the indication should only be used as an approximate guide. ● When handling the watch, exercise caution with the serrated edge of the driving wheel, which is sharp and could potentially cause injuries. In order to prevent potential injury from the serrated edge of the driving wheel, keep the driving wheel locked while wearing the watch during normal use. 8 English ROTATING COMPASS BEZEL (using the 24-hour hand to indicate directions) How to use the compass bezel Sun South 24-Hour hand S 165 150 195 210 [In the Northern Hemisphere] 1. Set "N" on the rotating compass bezel to the 12 o'clock position. The direction marks on the bezel are set as follows; 3 o'clock position: E (East) 6 o'clock position: S (South) 9 o'clock position: W (West) 105 120 E 255 W 240 75 285 300 60 Hour hand 2. While keeping the dial level, point the 24-hour hand in the direction of the sun. The direction marks indicate the corresponding directions. 330 30 345 15 N "N" Compass bezel North 12 o'clock position 9