Sennheiser HDA 300 Instruction Manual - Page 12

Specifications Specifications Frequency response Transducer principle Nominal impedance Characteristic SPL Max. nominal continuous input power Max input voltage Ear coupling Contact pressure Weight (with cable) Connection cable 20 - 20,000 Hz dynamic, closed 23  117 dB at 1 kHz, 0.5 V 500 mW (in accordance with EN 60268-7) 3.5 V, < 10 min circumaural 8.8 N ± 0.5 N approx. 490 g approx. 2.2 m, single-sided Pin assignment of the 6.35 mm jack plug (mono) Red plug = right side of the headphone 1 Audio High (red wire) 2 Audio Low (blue wire) Blue plug = left side of the headphone 1 Audio High (yellow wire) 2 Audio Low (green wire) Manufacturer declarations Warranty Sennheiser GmbH & Co. KG gives a warranty of 24 months on this product. For the current warranty conditions, please visit our website at www.sennheiser.com or contact your Sennheiser partner. FOR AUSTRALIA ONLY Sennheiser goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. This warranty is in addition to other rights or remedies under law. Nothing in this warranty excludes, limits, or modifies any liability of Sennheiser which is imposed by law, or limits or modifies any remedy available to the consumer which is granted by law. 10 | HDA 300