Sennheiser MEB 114 Product specification Dantetm Kit MEB 114-S - Page 2

PRODUCT SPECIFICATION 2/6 Dante™ Kit MEB 114-S SPECIFICATIONS SL DI 4 XLR Audio Inputs Input type Gain Input impedance Maximum input levels Phantom power Balanced and RF filtered 0 dB, +15 dB, + 30 dB, +45 dB, software selectable 10 dB pad, software selectable > 1.8 KΩ @ any gain +18 dBu @ 0 dB gain, with pad +8 dBu @ 0 dB gain, no pad -7 dBu @ +15 dB gain, no pad -22 dBu @ +30 dB gain, no pad -36 dBu @ +45 dB gain, no pad +48 V, 10 mA per input, software selectable Audio performance EIN System THD+N Frequency response -113 dBu < 0.02 % @ any gain input signal 3 dB below maximum 20 Hz - 20 kHz MEB 114-S Transducer principle pre-polarized condenser microphone Acoustic principle boundary layer microphone Pick-up pattern cardioid Frequency response 40 Hz - 20 kHz Nominal impedance at 1 kHz 200 Ω Sensitivity 10 mV/PA Max. sound pressure level 140 dB Equivalent noise level 29 dB (A) Equivalent noise level rated 39 dB (CCIR) as per CCIR 468-3 Dynamic range 111 dB (A) Phantom power P24-P48 Current consumption 5.3 mA Connectors Mic Out - tiny XLR-3M Logic out high level output voltage > 2.4 V low level output voltage > 0.4 V Logic in high level input voltage > 2.0 V low level input voltage > 0.8 V Dante™ network Physical level Connector Cable quality Transmission speed Daisy chain Standard Ethernet Single RJ-45 CAT-5 100 Mbps 2 units when powered by 802.3af PoE 3 units when powered by external +12 V DC power supply (Sennheiser NT 12-50CS) Product properties Power requirements Power consumption Dimensions (W x H x D) Weight Operating temperature Class 0 802.3af PoE PD compliant +12 V DC 2.7 W (225 mA) @ +12 V DC, no phantom power 5.5 W (460 mA) @ +12 V DC, 10 mA phantom power load per input 219 x 38 x 120 mm (8.63" x 1.50" x 4.74") 0.77 kg (1.7 lbs) 0 °C - 40 °C (32 °F - 104 °F) LED light ring color Microphone modes Connection Pin assignment logic connector Weight Dimensions (W x D x H) Operating temperature red/green Toggle on / off Push to mute Push to talk permanent on clip contact for logic trigger signal at the logic connector: Logic in (LED control) GND Logic out (switch signal) 291 g 85 x 100 x 25 mm (3.35" x 3.94" x 0.98") -10 °C to +50 °C (+14 °F to +122 °F)