Sennheiser freePORT Vocal Set Instructions for Use - Page 6

Connecting the receiver ̈ Insert the DC connector on the mains cable into the DC socket Ƹ and connect it to the mains. The green LED for operation indication (POWER) · lights up and the receiver is ready for operation. ̈ To deactivate the receiver, remove the mains plug from the mains outlet. Aligning the antennas ̈ Set up the antennas and align them upwards in a V-shape. The LEDs A and B indicate which diversity section (i.e. which antenna) is active. Connecting the amplifier/mixing console ̈ Connect the amplifier/mixing console to the XLR-3M socket ¾ or the ¼" (6.3 mm) jack socket µ. ̈ Use the GAIN control ¸ to adapt the level of the audio output to the input of the amplifier or mixing console. The adjusted audio output level is common for both sockets. If the level is adjusted too high, the audio signal will be distorted. If, on the other hand, the level is adjusted too low, this will result in an audio signal with high background noise. Selecting and changing a channel You can change the channel on the receiver during running operation. The receiver then immediately receives on the new channel. ̈ Use a small screwdriver to set the channel selector switch ¿ to the desired channel. You can switch between four different channels ("Selecting a channel"). 5