Sharp 19C140 Service Manual - Page 7

19C140 SERVICE NUMBER ADJUSTMENT ITEM S01 PICTURE S02 TINT S03 COLOR S04 BRIGHTNESS S05 SHARPNESS S06 VERTICAL PHASE S07 HORIZONTAL PHASE S08 RF-AGC S09 VERTICAL AMP S10 VCO S11 R CUT-OFF S12 G CUT -OFF S13 B CUT-OFF S14 G GAIN S15 B GAIN S16 TRAP(3.58MHz) S17 BALANCE S18 C.C.POSITION S19 Y-MUTE S20 ENERGY SAVE OFFSET S21 D.D.E. OFFSET S22 OSD SETUP S23 TUNER SETUP OP OPTION DATA INITIAL VALUE RANGE ADJUSTMENT CONTENTS 55 00-7F 46 00-7F 32 00-7F 40 00-7F 28 00-3F Must be set to "24" 00 00-07 Must be set to "00" ~ "03" 12 00-1F 23 00-3F 20 00-3F 2C 00-7F 00 00-FF 00 00-FF 00 00-FF 7F 00-FF 7F 00-FF 00 00 or 01 Must be set to "00" 20 00-3F Must be set to "20" 17 00-7F 00 00,01,03 "00" = NORMAL, "01" = No Y, "03" = No VERTICAL 20 00-3F Must be set to "23" 03 00-1F Must be set to "03" 00 00-03 Must be set to "00" 00 00-01 Must be set to "00" 30 00-FF Must be set to "02" Table - A Holding down both the CH-up/down buttons on the TV set at service mode for more than 2 seconds will automatically write the above initial values into IC2101. PART REPLACED ADJUSTMENT NECESSARY UNNECESSARY NOTES IC2001 X Data is stored in IC2101. IC201 X The adjustment is needed to compensate for characteristics of parts including IC201. IC2101 X Holding down both the CH-up/down buttons on the TV set in the service mode for more than 2 seconds will automatically write the above initial values into IC2101. CRT X Adjust items related to picture tube only. Table - B 7