Sharp AR-160 Operation Manual - Page 65
Erase
UPC - 708562452861
View all Sharp AR-160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Erase Edge erase AA Centre erase A B A B Edge + Centre erase AB AB ELECTRONIC SORTING KIT (AR-EB3) This copier has an edge erase mode and a centre erase mode. ● Edge erase can be used to eliminate shadow lines around the edges of copies caused when thick paper or a book is used as an original. ● Centre erase can be used to eliminate the shadow produced by the bindings of bound documents. ● Edge + centre erase can be used to eliminate shadow lines around the edges of copies and to eliminate the shadow at the centre of copies. ● The erase width can be set from 0 to 20 mm in five steps using user program No. 16. See page 36. ● This feature cannot be used with the 2 in 1 or 4 in 1 feature. Electronic sorting kit (AR-EB3) OPTIONAL EQUIPMENT 1 Place the original on the original table and close the platen cover. ● If an optional single pass feeder (SPF) is installed, it can also be used for this feature. 2 Press the ERASE key to select the desired erase mode. ● To select the EDGE + CENTRE ERASE mode, press the ERASE key until both the EDGE and CENTRE indicators light up. 3 Check the copy paper size. ● If non-standard size paper or the bypass tray is used, the paper will be regarded as A3 size paper and the erase area will not be proper if the paper size is not A3. ● If an optional paper feed unit is installed, use the TRAY SELECT key to select the desired paper size. 63