Sharp AR-5316 Software Guide - Page 7

INSTALLING THE PRINTER DRIVER INSTALLATION IN WINDOWS 98/Me/2000 (USB CABLE) 1 The USB cable must not be connected to the machine. Make sure that the cable is not connected before proceeding. If the cable is connected, a Plug and Play window will appear. If this happens, click the "Cancel" button to close the window and disconnect the cable. 7 When the interface selection screen appears, select "USB" and click the "Next" button. Note The cable will be connected in step 10. 2 Insert the CD-ROM into your CD-ROM drive. 3 Double-click "My Computer" ( ), and then double-click the CD-ROM icon ( ). 4 Double-click the "setup" icon ( ). Note If the language selection screen appears after you double click the "setup" icon, select the language you wish to use and click the "Next" button. (Normally the correct language is selected automatically.) 5 Read the message in the "Welcome" window and then click the "Next" button. 6 When you are asked how the printer is connected, select "Connected to this computer" and click the "Next" button. 8 Follow the on-screen instructions. In Windows 2000, if the following screen Caution appears while the files are being copied (the message may appear more than once), click the "Yes" button. 9 When the finish screen appears, click the "OK" button. Note After the installation, a message prompting you to restart your computer may appear. In this case, click the "Yes" button to restart your computer. 10 Make sure that the power of the machine is turned on, and then connect the USB cable. (p. 8) Windows will detect the machine and the Plug and Play screen will appear. 11 Follow the instructions in the Plug and Play screen that appears in your version of Windows to begin the installation. This completes the installation of the software. Configure the printer driver settings as explained in "CONFIGURING THE PRINTER DRIVER" (p. 9). 5