Sharp CD-BA120 CD-BA120 Operation Manual - Page 16

HEADPHONES q Before plugging in or unplugging the headphones, make sure the volume level is reduced. q Be sure your headphones have a 1/8" (3.5 mm) diameter plug and are between 16 ohms and 50 ohms impedance. The recommended impedance is 32 ohms. q When headphones are connected, the speakers are disconnected automatically. Adjust the VOLUME control for the desired volume. RESETTING THE MICROCOMPUTER EQUALIZER X-BASS/ DEMO POWER ON/ STAND-BY Reset the microcomputer under the following conditions: q To erase all of the stored memory contents (clock and timer settings, and tuner and CD presets). q If the display is not correct. q If the operation is not correct. 1 Press the ON/STAND-BY button to enter the stand-by mode. 2 While pressing down the 0 / R button and the EQUALIZER/X- BASS/DEMO button, hold down the ON/STAND-BY button for at least 1 second. q "CLEAR AL" will appear. Caution: q The operation explained above will erase all data stored in memory including clock and timer settings, and tuner and CD presets. TRANSPORTING THE UNIT POWER ON/ STAND-BY CD OPEN/ CLOSE Before you move this product to a new location, proceed as follows: 1 Press the ON/STAND-BY button to turn the power on. 2 Press the CD button. 3 Press the OPEN/CLOSE button to open the disc tray. q Remove all CDs inserted in the unit. 4 Press the OPEN/CLOSE button to close the disc tray. q Make sure that "NO DISC" is displayed. 5 Press the ON/STAND-BY button to enter the stand-by mode, and then unplug the AC power cord from the AC outlet. 15