Sharp CD-BA1600 CD-BA1600 Operation Manual - Page 16
Using External Units, Resetting The Microcomputer, Transporting The Unit
View all Sharp CD-BA1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
USING EXTERNAL UNITS To the line output jack RCA cord RESETTING THE MICROCOMPUTER X-BASS/ DEMO POWER ON/ STAND-BY TRANSPORTING THE UNIT POWER ON/ STAND-BY OPEN/ CLOSE CD s Video/Auxiliary (Audio signal) input To listen to or record signals from external sources through this unit: 1 Use a separately available RCA cord to connect the desired external unit to the VIDEO/AUX jacks. (red → right channel, white → left channel) q When using video equipment (Laser Disc player or VCR), be sure to connect the audio output to this unit and the video output to a television. 2 Press the ON/STAND-BY button to turn the power on. 3 Press the VIDEO/AUX button. 4 Operate the external unit. 5 To record the sound from the external unit, perform steps 2 - 4 of the "Recording from the built-in radio" section on page 13. Note: q To prevent hum interference, do not place this unit near a television receiver. s Headphones q Before plugging in or unplugging the headphones, make sure the volume level is reduced. q Be sure your headphones have a 1/8" (3.5 mm) diameter plug and are between 16 ohms and 50 ohms impedance. The recommended impedance is 32 ohms. q When headphones are connected, the speakers are disconnected automatically. Adjust the VOLUME control for the desired volume. Reset the microcomputer under the following conditions: q To erase all of the stored memory contents (clock and timer settings, and tuner and CD presets). q If the display is not correct. q If the operation is not correct. 1 Press the ON/STAND-BY button to enter the stand-by mode. 2 While pressing down the 0 / R button and the X-BASS/DEMO button, hold down the ON/STAND-BY button for at least 1 second. q "CLEAR AL" will appear. Caution: q The operation explained above will erase all data stored in memory including clock and timer settings, and tuner and CD presets. Before you move this product to a new location, proceed as follows: 1 Press the ON/STAND-BY button to turn the power on. 2 Press the CD button. 3 Press the OPEN/CLOSE button to open the disc tray. q Remove all CDs inserted in the unit. 4 Press the OPEN/CLOSE button to close the disc tray. q Make sure that "NO DISC" is displayed. 5 Press the ON/STAND-BY button to enter the stand-by mode, and then unplug the AC power cord from the AC outlet. 15