Sharp CD-E77 Service Manual - Page 10

CD-E700/CD-E77 CD MECHANISM SECTION Perform steps 1, 2, 3, 10, 11,12 and 13 of the disassembly method to remove the CD mechanism. How to remove the loading motor (See Fig. 10-1) 1. Bend the hooks (A1) x 5 pcs., to remove the loading motor. Loading Tray Loading Motor Loading Motor PWB (A1)x5 How to remove the pickup unit (See Fig. 10-2) 1. Remove the stop washer (B1) x 1 pc., to remove the gear (B2) x 1 pc. 2. Remove the screws (B3) x 2 pcs., to remove the shaft (B4) x 1 pc. 3. Remove the pickup. Note After removing the connector for the optical pickup from the connector wrap the conductive aluminium foil around the front end of connector so as to protect the optical pickup from electrostatic damage. Figure 10-1 (B3)x2 ø2.6x6mm Stop Washer (B1)x1 Shaft (B4)x1 ADJUSTMENT Pickup Unit Gear (B2)x1 CD Mechanism Figure 10-2 MECHANISM SECTION • Driving Force Check Torque Meter Specified Value Play: TW-2111 Tape 1: Over 80 g Tape 2: Over 80 g • Torque Check Torque Meter Play: TW-2111 Fast forward: TW-2231 Rewind: TW-2231 Specified Value Tape 1 Tape 2 30 to 80 g.cm - - 30 to 80 g.cm 70 to 180 g.cm 70 to 180 g.cm • Tape Speed Test Tape Normal MTT-111 speed Adjusting Point Variable Resistor in motor. Specified Instrument Value Connection 3,000 ± 30 Hz Speaker Terminal (Load resistance: 6 ohms) TAPE MECHANISM Tape Motor - 10 - Variable Resistor in motor Figure 10-3