Sharp CD-G100000 CD-G10000 Operation Manual - Page 41
Troubleshooting chart
View all Sharp CD-G100000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Headphones z Before plugging in or unplugging the headphones, reduce the volume. z Be sure your headphones have a 1/8" (3.5 mm) diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms. z Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOL. control. Troubleshooting chart CD-G10000 CP-G10000S Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center. General Symptom Possible cause z The clock is not set to the z Did a power failure occur? Reset correct time. the clock. (Refer to page 19.) z When a button is pressed, z Set the unit to the power standthe unit does not respond. by mode and then turn it back on. z If the unit still malfunctions, reset it. (Refer to page 43.) z No sound is heard. z Is the volume level set to "0"? z Are the headphones connected? z Are the speaker wires disconnected? References CD player Symptom Possible cause z Playback does not start. z Is the disc loaded upside down? z Playback stops in the mid- z Does the disc satisfy the stan- dle or is not performed dards? properly. z Is the disc distorted or scratched? z Playback sounds are z Is the unit located near excessive skipped, or stopped in the vibrations? middle of a track. z Is the disc very dirty? z Has condensation formed inside the unit? 41